SIL-411: Commercial-Grade SDI-12 Digital Output Standard Field of View Infrared Radiometer Sensor

$465.00

The SIL-411 has an SDI-12 digital output and 5 m high-quality cable terminating in pre-tinned pigtail leads for easy connection to dataloggers and controllers. The sensor has a 22° half-angle field of view and a response time of 0.6 seconds. Typical applications include plant canopy temperature measurement for use in plant water status estimation, road surface temperature measurement of determination of icing conditions, and terrestrial surface (soil, vegetation, water, snow) temperature measurement in energy balance studies. 

 

FOR MORE PRODUCT INFORMATION, CHECK OUT THESE LINKS

• Product Manual

• Specification Sheet

• Technical Drawing

 

RESEARCH-GRADE VS COMMERCIAL-GRADE

 Research-GradeCommercial-Grade
Accuracy ± 0.2 C from -30 to 65 C ± 0.5 C from 0 to 50 C
Shield Material Powder-coated aluminum with a polished interior Rugged, polished, UV-resistant ASA plastic
Field of View Three circular with two horizontal apertures Single 22° half-angle and one horizontal aperture
Cost More accurate for higher cost Less accurate for lower cost
Cable Connector IP68 stainless-steel cable connector to simplify sensor removal No connector

MORE INFORMATION ON APOGEE INFRARED RADIOMETERS >> click here

Full Description
Where to Buy

The SIL-411 has an SDI-12 digital output and 5 m high-quality cable terminating in pre-tinned pigtail leads for easy connection to dataloggers and controllers. The sensor has a 22° half-angle field of view and a response time of 0.6 seconds. Typical applications include plant canopy temperature measurement for use in plant water status estimation, road surface temperature measurement of determination of icing conditions, and terrestrial surface (soil, vegetation, water, snow) temperature measurement in energy balance studies. 

 

FOR MORE PRODUCT INFORMATION, CHECK OUT THESE LINKS

• Product Manual

• Specification Sheet

• Technical Drawing

 

RESEARCH-GRADE VS COMMERCIAL-GRADE

 Research-GradeCommercial-Grade
Accuracy ± 0.2 C from -30 to 65 C ± 0.5 C from 0 to 50 C
Shield Material Powder-coated aluminum with a polished interior Rugged, polished, UV-resistant ASA plastic
Field of View Three circular with two horizontal apertures Single 22° half-angle and one horizontal aperture
Cost More accurate for higher cost Less accurate for lower cost
Cable Connector IP68 stainless-steel cable connector to simplify sensor removal No connector

MORE INFORMATION ON APOGEE INFRARED RADIOMETERS >> click here

Current Stock:
Input Voltage Requirement 5.5 to 24 V DC Current Draw 1.5 mA (quiescent), 2.0 mA (active) Calibration Uncertainty (0 to 50 C), when target and detector temperature are within 20 C 0.5 C Measurement Repeatability Less than 0.05 C Stability (Long-term Drift) Less than 2 % change in slope per year when germanium filter is maintained in a clean condition Response Time 0.6 s, time for detector signal to reach 95 % following a step change; fastest data transmission rate for SDI-12 circuitry is 1 s Field of View 22° half angle Spectral Range 8 to 14 µm; atmospheric window Operating Environment -50 to 80 C; 0 to 100 % relative humidity (non-condensing) Dimensions 23 mm diameter, 60 mm length Mass 190 g (with 5m of lead wire) Cable 5 m of six conductor, shielded, twisted-pair wire; TPR jacket (high water resistance, high UV stability, flexibility in cold conditions); pigtail lead wires Warranty 4 years against defects in materials and workmanship Manufactured Assembled in the USA